• High Voltage Stripper is a professional strength stripper designed for removing difficult or built up floor finish.

• High Voltage Stripper dissolves multiple coats of floor seal/finish for ease of removal.  

• High Voltage Stripper is a super concentrate that can be used at multiple dilution ratios to accommodate even the toughest finish build up.  

• Directions for use

High Voltage Stripper is rated as a 1:10 dilution ratio for normal stripping. When moderate or heavy build-up situations occur, adjust dilution ratio to increase potency.  

• Preparation

NOTE: Before performing the stripping procedure, ensure work area is secure and safety parameters have been set using “Wet Floor” cones, signs, placards, danger or caution tape, or safety gates.

Perform area preparation function by removing objects that may impede the service and dust mop the area to remove dry soil.

Mix High Voltage Striper in accordance with manufacturers recommended dilution ratios. Adjust dilution ration as needed to address finish build-up condition.

• Application

High Voltage Stripper may be applied with mop and bucket, or solution applicator. Never put High Voltage Stripper in solution tank of automatic scrubbing machine.

Apply liberal amount of diluted solution to desired cleaning area.

Allow to dwell for an appropriate time (usually 10 – 15 Minutes).

Agitate solution with rotary floor machine or automatic scrubbing machine and appropriate stripping pads and/or brushes.

Evacuate contaminated solution with wet vacuum.

Rinse the floor with clean water and detail edges, corners and baseboards.

Rinse the floor thoroughly with clean water.

Inspect floor, if floor finish is still visible, repeat process. After floor is completely dry, apply multiple coats of Fusion Floor Seal/Finish to desired appearance level, apply one coat of TA² Penetrating Hardener and burnish to high gloss. Apply Plastiflex or Dry Brite Floor Finish if desired.

Back